SBC-9138/9238 Multi- Stage Smart Battery Chargers User Manual Keep this manual in a safe place for quick reference at all times. This manual contain
I. Trouble Shooting PROBLEM INDICATIONS POSSIBLE CAUSES SUGGESTED SOLUTION Charger does not work LCD display not turn on No AC power AC input s
J. Specifications Model SBC-9138 SBC-9238 AC Input Voltage 200-240VAC, 50Hz~ Yes AC Input Current at Full Load (at 230VAC) 2.9A Output (Charge) Volt
Fig.1 INTRODUCTION Congratulations on purchasing our new Multi-Stage (IU0U) Switching Mode Smart Battery Charger. This software based MCU control 7
3. Recondition mode switch Simple press and hold 3 seconds the switch to set the charger to go with recondition charge in next cycle. 4. Battery
e. Power level meter Displays current power level (the % of output current selected, details please see section F) f. Charging status NORMAL: C
Once Self-Testing completed, the LCD display will show as below and remind you the charger are ready for battery connection. Once
D. Normal Multi-Stage (IUoU) Charging Operation The 7-stage IU0U charge algorithm ensures fast, complete and at the same time gentle charging of t
Stage 7. STANDBY MODE - The constant voltage charging In this stage, the charging voltage at this mode will be 4% less than the Float voltage only f
G. Temperature Sensor Warning! The temperature sensor must be installed at the Negative Terminal of the battery terminal, wrong connection to the
F4: Fan stuck or not working F5: Faulty battery F6: Battery temp over 60°C as detected by remote sensor F7: short circuit > 5 sec shut do
Comments to this Manuals